Eldes ESIM262, Руководство пользователя

Страница: 23 / 52

MANUAL ELDES ESIM262 V1.1 23
EN
Z (ATZ re ž im as )
CO
M
Z(1
-6)
5.6 k
3.3k
Z(7-12) Z(1-6)
1.6 System installation
1. Place SIM card in the holder but make sure that SIM card PIN code request is disabled. (PIN code can be disabled by putting
SIM card into mobile phone and following proper menus). SIM card should not have any remaining SMS messages. Then con -
nect antenna.
2. Install audio signalling device close to DALLAS button reader in order to hear system engaging or disengaging time-out
period. Light emitting diode could be used instead of audio signalling device, or both. Enclosure ED1 is recommended for
convenient installation.
3. Connect the circuit as shown in Fig. No.2. Fig. No.3 illustrates connection circuit of temperature sensor and various ways of
connecting the secured zones. Fig. No.4 presents connection circuit of the secured zones using ATZ (zone duplicating) mode.
ATZ can be enabled only using computer ESIM262 configuration tool.
4. Connect back-up battery and main power supply (transformer). The system will start in less than a minute. Indicator PWR will
report external power supply status. Indicator STATUS should be blinking which indicates successful microcontroller operati-
on.
USEFUL INFORMATION
The system can be used without DALLAS button, but it’s good to have it as emergency switch in case your mobile phone is
dead or missing. Also DALLAS button can be uses as main key to enable or disable system
USEFUL INFORMATION
To increase system reliability, it is recommended not to use prepaid SIM cards. The system would fail to send any messages
upon depletion of prepaid account. Also it is recommended to disable call forwarding and voice mail.
USEFUL INFORMATION
It is worth to choose the same GSM cellular provider as most users use assuring fast and reli-able SMS message delivery and
phone call connection.
WARNING
Even though alarm system ESIM262 installation is not complicated, it is recommended to be performed by a person with basic
knowledge in electrical engineering and electronics to avoid any system damage.