Eldes ESIM262, Руководство пользователя

Страница: 18 / 52

Copyright © “ELDES UAB”, 2009. All rights reserved
It is not allowed to copy and distribute information in this document or pass to a third party without advanced written authorization by “ELDES UAB”
“ELSDES UAB” reserves the right to update or modify this document and/or related products without a warning. Hereby, ELDES UAB declares that this GSM
Alarm System ELDES ESIM 262 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
The declaration of conformity may be consulted at www.eldes.lt/ce
Manuall v1.1
Safety instructions
Please read and follow these safety guidelines in order to maintain safety of operators and people around:
• Alarm system ELDES ESIM 262 (later referenced as system or detector) has radio transceiver operating in GSM900 and GSM1800
bands.
• Don’t use the system where it can be interfere with other devices and cause any potential danger.
• Don’t use the system with medical devices.
• Don’t use the system in hazardous environment.
• Don’t expose the system to high humidity, chemical environment or mechanical impacts.
• Don’t attempt to personally repair the system. Any system repairs must be done only by qualifi ed, safety aware personnel
The system must be powered by main 16-24V 1.5A AC max or 18-24V 1.5A DC max power supply and back-up power supply
– 12V 1,3-7Ah battery. Both mentioned power supplies must be approved by LST EN60950-1 standard
Any additional device connected to the alarm system ESIM262 system must be powered up by a LST EN60950-1 approved
supply.
External power supply can be connected to AC mains only inside installation
room with automatic 2-pole circuit breaker capable of disconnecting circuit
in the event of short circuit or over-current condition. Open circuit breaker
must have a gap between connections of more than 3mm.
Mains power and back-up battery must be disconnected before any installation or tuning work starts. The system installa-
tion or maintenance must not be done during stormy conditions.
The system must be used only with approved back-up battery to avoid fi re or explosion hazards. Special care must be taken
connecting positive and negative battery terminals.
Backup battery must be connected via the connection which in the case of breaking would result in disconnection of one
of battery pole terminals.
The device is switched off by 2-pole circuit breaker and disconnecting back-up battery connector.
Fuse F1 type – Slow Blown 3A. Replacement fuses have to be exactly the same as indicated by the manufacturer.
WARNING: in order to avoid fi re or explosion hazards the system must be used only with approved back-up battery. Special
care must be taken when connecting positive and negative battery terminals
16-24
AC/DC
Dvipolė automatinė apsauga
L
N
230V AC
ESIM262
The WEEE (Waste Electrical and Electronic Equipment) marking on this product (see right) or its documentation indicates that the pro-
duct must not be disposed of together with household waste. To prevent possible harm to human health and/or the environment, the
product must be disposed on in an approved and environmentally safe recycling process. For further information on how to dispose
of this product correctly, contact the system supplier, or the local authority responsible for waste disposal in your area.