elddis XPLORE, Руководство пользователя

Страница: 37 / 134

8-4
HOW TO USE YOUR CARAVAN’S EQUIPMENT
3 BURNER HOB
This appliance is designed for cooking food,
any other use is incorrect and dangerous.
Failure to install the appliance correctly or
improper use could invalidate any warranty or
liability claims and lead to prosecution.
Ventilation
The use of a gas cooking appliance results in
a production of heat and moisture in a room
in which it is installed. Ensure that the kitchen
is well ventilated. Keep natural ventilation
holes open or install a mechanical ventilation
device, (mechanical extractor hood).
Prolonged intensive use of the appliance may
call for additional ventilation, for example
opening a window.
The appliance must be positioned free from
draughts, which may affect the combustion in
a manner that will prevent the accumulation
of unburnt gas. When in use ensure that air
vents are not inadvertently blocked or shut
off.
Burner Operation
The burners on the appliance have fixed
aeration and no adjustment is required. The
burners should flame as follows:
Propane - The flames should burn quietly
with a blue/green colour with no sign of
yellow tips.
Butane - Normally on initial lighting, a small
amount of yellow tipping will occur and then
slightly increases as the burner heats up.
IMPORTANT
Avoid old or misshapen pans as these
may cause instability.
The lid must be opened fully prior to
using the hotplate burners.
1. Ensure gas cylinder/supply is connected
and turned on. In the event of a gas smell
turn off at gas cylinder/mains and contact
supplier.
2. Flame supervision: Each burner is
controlled individually and is monitored
by a thermocouple probe. In the event of
the burner flames being accidentally
extinguished, turn off the burner control
and do not attempt to re-ignite the burner
for at least one minute.
3. To light: Push in the control knob and turn
to full rate. Hold a lighted match or taper
to the burner and push the control knob
in and hold. It is necessary to hold the
knob depressed after the burner has
ignited for approximately 10 - 15
seconds, to allow the thermocouple
probe to reach temperature, before
releasing the knob. Should the flame go
out when the knob is released, the
procedure should be repeated holding
the knob depressed for slightly longer.
4. For models fitted with optional Spark
Ignition the procedure is similar:
Models with Auto Spark Ignition -
pushing the control knob automatically
starts the spark ignition circuit. To light
the burner follow the procedure in (3)
above, except that the burner can be
ignited by depressing the ignition button
located on the fascia.
Models with Manual Spark Ignition -
follow the procedure in (3) above, except
that the burner can be ignited by
depressing the ignition button located on
the fascia.
OFF FULL
RATE LOW
RATE