ELCOM Uniq PC 190, Руководство пользователя

Страница: 51 / 55

ADJUSTING ROTATION OF THE UNIQ PC JOINT
To change the rotation of the joint for Uniq PC version with the joint, you must first loosen the locking screws
which prevent the spontaneous change of position Uniq PC due to vibrations. To reach these screws you
must first loosen the protective cuff on the side closer to the Uniq PC and slide it to the opposite side so that
the screw heads were visible as shown in the figure below. Then loosen the two screws with an hex wrench.
Adjust Uniq PC position according to your requirements and tighten the locking screws. Finally, secure the
sleeve in its original position. Be careful not to disturb watertightness of the system.
two screws
CARE
Prior to cleaning the device, always switch it off and disconnect it from the power source.
For cleaning the external cover use a damp towel made of soft fibers. Do not use caustic cleaning agents
or solvents as they can cause damage or discoloration of the cover’s plastic casing.
For cleaning the surface of the display (the touch panel) use a dry cloth. If the display is very dirty, a apply
small amount of a quality product for cleaning LCD displays on the dry dusting cloth. Never apply cleaning
solutions directly onto the display.
Speaker area can be cleaned using in similar manner using damp towel and if needed with small amount
of the suitable cleaning agent.
Uniq PC 190 (KD) is secured against the ingress of water, but it may not be cleaned by immersion. Prevent
the penetration of liquids to the inside of the device as they can cause damage to it.
51
Mounting and care