Thank you for choosing the Uniq PC. Before you begin using the device, read these instructions to become
familiar with the device’s features and functions. Be sure to save this manual for future use. It will help you
solve problems that may arise. The latest version of the manual is freely available on the Web site at www.
elcom.eu in the Support section.
IMPORTANT NOTICES
Please pay attention to the following notices. They will help you avoid possible damage to the device and
potential injury which could result from improper use of the device. With damage to the device caused by
non-observance of the procedures mentioned in these notices, the legal warranty expires due to improper
handling with the product.
• Do not leave the switched-on product unattended!
• Install the product in a place where it will not be exposed to direct sunlight, unusual changes in temperature
(below 0°C and over 45°C) or high humidity. Installation in an unsuitable place could cause damage to the
casing and electrical components.
• Procedure for disconnection of the power connector:
1 - Connected connector.
2 - Grab the connector by plastic housing, back pulling of housing
release the safety catch and it enable to disconnect power connector
strength.
3 – Plastic housing of disconnected connector returns to the starting
position itself.
• Upon carrying the product from a cool environment to a warm one, or vice versa, do not switch it on for at
least 30 minutes.
• The product should not be operated by a person with wet hands. Water could penetrate to the interior and
cause damage to the parts.
• Clean the external surface with a soft, dry cloth. Never use caustic cleaning agents. The use of such
chemicals could lead to damage to the product. Do not clean the product with sprayed water and do not
submerge the product in water.
• If the product is not working properly, take it to an authorized service center technician. Do not attempt to
repair the product yourself. Do not open the product!
• Use only the AC/DC adapter provided or an adapter recommended by an authorized dealer. The use of
other types of adapters may result in damage to the adapter or the product. First connect the power cable
to the Uniq PC, and only afterwards to the power source! Never disconnect or connect a power cable,
not even a VGA cable, if the Uniq PC or a connected display is switched on!
• To Uniq PC 19 can be connected to an external device with a maximum length 3 m of USB cable. For
RS232 and Enthernet you can use a maximum cable length of 30 m.
• Notice: The adapter is designated for interior use only!
• The use of sharp objects for operating the touch panel can cause serious damage or destroy the touch panel.
• Electronic equipment producing interference, connected in the same power circuit, can cause the improper
functioning of the device. In such a case, use special anti-jamming aids recommended by the producer.
32
Introduction
Содержание Uniq PC 190
