Elation PIXEL BAR 120IP, Руководство пользователя

Страница: 11 / 26

11
www.elationlighting.com
I N S T A L L A T I O N G U I D E L I N E S
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial electrical
and construction codes and regulations.
Before rigging/mounting the fixture to any metal truss/structure or placing the fixture on any
surface, a professional equipment installer MUST be consulted to determine if the metal
truss/structure or surface is properly certified to safely hold the combined weight of the
fixture, clamps, cables, and accessories. Overhead fixture installation must always be
secured with a secondary safety attachment, such as an appropriately rated safety cable
that meets all local, national, and country codes and regulations.
Fixture ambient operating temperature range is -4° to 113°F. (-20° to 45°C)
DO NOT use the fixture under or above this temperature.
Fixture should be installed in areas outside walking paths, seating areas, or away from
areas were unauthorized personnel might reach the fixture by hand.
NEVER
stand directly below the fixture when rigging, removing or servicing.
Allow approximately 15 minutes for the fixture to cool down before serving.
MOUNTING YOKE
This fixture includes an adjustable sliding position mounting yoke and safety cable rigging
point attached to the fixture. (see the illustration below) ( Pixel Bar 120IP includes 2 yokes)
To adjust the mounting yoke to a desired position, loosen thumb screw, move the yoke to
the desired position, then tighten the thumb screw securely.
DO NOT OVER TIGHTEN THE THUMB SCREW!
SURFACE MOUNTING
The fixture can be mounted to a flat surface via the mounting yoke using appropriate
mounting hardware (not included). Use careful planning when surface mounting fixtures to
allow ample space for power/data cables.