ELAR DW BRICK ™
©Elation Professional, Los Angeles Ca.
15
www.ElationLighting.com
fixture. That means changing the settings of one channel will only affect the selected fixture.
In the case of the ELAR DW BRICK™, which is a 5 channel fixture (default), you
should set the starting DMX address of the first unit to 1, the second unit to 6 (5 + 1),
the third unit to 11 (6 + 5), and so on.
Note:
During start-up the ELAR DW BRICK ™ will automatically detect whether a DMX data
signal is being received or not. If a DMX data signal is being received, the display will show
"A.XXX" (XXX
representing the actual DMX address). If the fixture is not receiving a DMX
signal the display will flash
"A.XXX" (XXX
representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3-pin or 5-pin XLR plug (cable with DMX signal from controller) may not be
connected or is not inserted completely into the DMX input jack.
- The DMX controller is switched off or defective.
- The DMX cable from the controller merging with included IP Rated Cable adapter is
not connected securely
- The DMX cable or connector is defective.
- A DMX terminator has been inserted into the last fixture in your DMX chain.
Содержание ELAR DW BRICK
Страница 31: ...ELAR DW BRICK Elation Professional Los Angeles Ca 30 www ElationLighting com 13 PHOTOMETRIC DATA...
Страница 32: ...ELAR DW BRICK Elation Professional Los Angeles Ca 31 www ElationLighting com 14 DIMENSIONAL DRAWINGS...
Страница 34: ...ELAR DW BRICK Elation Professional Los Angeles Ca 33 www ElationLighting com 16 CIRCUIT SCHEMATIC...
