EN
11
Start
Mechanical wind-up timer.
Turn the timer’s knob to the desired running time.
Timer
The drying room dehumidifier can be fitted with one of the following timers:
• Mechanical wind-up timer.
• Electronic timer with preset time.
• Timer with hygrometer.
If the drying room dehumidifier is fitted with a timer with preset time, set the
required time as follows:
1.
Turn off the power to the drying room dehumidifier using the main
(operation) switch.
2. Open the cover on the timer and set the operating time (factory setting 2.5 hours)
with selector B, which is graduated in hours.
Adjust the operating time on the time relay as follows:
1. Turn selector A to position “1–10 h” (1–10 hours).
2. Turn selector B to position “2.5” (recommendation 2.5 hours).
3. Selector C to position “C”.
4.
Refit the cover and switch on the dehumidifier using the main (operation) switch.
THERMOSTAT (GT1:1)
Thermostat GT1:1 controls the heating coil and is adjustable from 0 to 9
(corresponds to approx. 0–50°C).
The thermostat is located inside the filter hatch.
Remove the upper screws on the filter hatch. Hinge down the hatch. The thermostat
is inside the front panel of the electrical box.
Standard setting = 5
GENERAL DRYING ADVICE
•
Laundry that is to be dried should be spun for at least 5 min. before hanging.
Higher spin speed decreases the drying time. Therefore avoid low spinning speeds
if the drying room dehumidifier has limited running time.
•
Hang your laundry evenly around the drying room.
• Doors and windows should be closed, otherwise there is a risk that humid air will
be added continuously.
NOTE!
Never turn the knob backwards without first
turning it fully clockwise.
D
Selector A
Selector B
Selector C
GT1:1
