Repeat the procedure on CPU water block
Repeat the procedure on the Pump/Reservoir unit.
Screw in the fitting on the outlet and inlet port.
Repeat the procedure in the graphics card waterblock, if
present.
Take the cable with adaptors from the pump
delivery.
Connect pumps female 4-PIN connector to male
connector of the motherboard.
Connect 4-pin Molex female connector to male Molex
connector of the power supply.
Prepare enclosed Y fan splitter cable.
To connect the fans plug in 3-PIN female fan
connectors to male fan splitter cable.
Connect the female fan splitter cable to motherboards
male connector.
Prepare the ATX bridging plug enclosed with the
kit. This gadget allows powering up the PSU
without powering up the whole computer.
Plug in the ATX bridging plug. Make sure nothing
except the pump is plugged to the power supply.
Take about 900 mL of distilled water
