Mount your pump holder using two M4x12 screws from the front side. Use the
pre-drilled holes, as shown on the sketch.
Secure the assembly screws using PVC washers and two M4 nuts.
Mount the pump/reservoir combo on the pump holder. Please use four rubber
dumpers, pvc washers and four M4x6 screws as shown on the sketch.
Make sure all the screws are tight as the vibrations that come from the pump may
loosen them.
Examine the water loop diagram
Take a measure of required tubing length.
Cut the tube on marked spot.
Install the compression fitting to one and 90
°
adapter with compression fitting on the other G1/4
opening on radiator.
Install the tube on the fittings. If needed heat the
tube in warm water.
Screw in the securing ring of the fitting to secure the
tube properly
