/ 26 /
STEP 5
EK-ATX
Bridging Plug
Power supply ATX cable
STEP 5:
Plug in the EK-ATX Bridging Plug (EAN 3831109867716) to your male 24-
pin ATX PSU cable to jump-start your computer. It is a good practice to also
unplug the fans from the fan splitter hub (see page 10).
Make sure nothing except the fan splitter hub is plugged to the power supply.
All motherboard-, graphics car- or SATA power should be disconnected!
Before powering up the Phoenix, make sure that water block is con-
nected to the Phoenix Radiator Core module, so that coolant can cir-
culate!
STEP 6 and 7:
Upon powering up the Phoenix, coolant level will most likely drop and the unit
(namely pump) might operate loudly. This is caused by air still present in the
loop. When it does, you must add additional coolant until the liquid line is clear-
ly visible and the unit is full.
The air is being bled from the system as the pump is running. The procedure
for assisted bleeding air from the system is as following:
1) Turn off your computer (or power supply unit)
2) Add more coolant to the unit (top it off)
3) Turn the power on, let it run for 5 minutes
4) Shake and tilt the unit to force the remaining air bubbles out. Reinstall the
plug to prevent coolant spillage during this substep.
5) Repeat substeps 1 to 4 until the unit is full
Diminished rattling is a good sign that the loop is free of air!
STEP 6 and 7
Coolant
Содержание EK-MLC PHOENIX Series
