/ 26 /
Fitting Ring
Fitting Ring
STEP 3
If you have assembled the components according to this
installation manual, all the compression fittings should
have already been installed.
To fit the tubing onto the compression fittings, you will have to
remove the fitting rings by rotating them in a counter-clockwise
direction.
Tubing
STEP 3
STEP 5
STEP 4
STEP 4
Slide the fitting ring along the tube with the threaded side facing the
fitting barb.
Install the tube on the fitting barb. You can do that by forcing it to slide
over the edge as far as it goes. If needed, heat the tube in warm water.
STEP 5
Slide the fitting ring toward the fitting barb and tighten it in a
clockwise direction as far as it goes.
Repeat the procedure on all fittings to connect your liquid cooling loop.