/ 20 /
STEP 3
Align the holes of the radiator with the ones in the PC chassis.
Take four (4) UNC 6-32 x 5mm screws for each fan and guide them
through the holes in the chassis, then screw them into the threaded
holes of the radiator. Tighten them in a clockwise direction using
the enclosed Allen key.
STEP 4
Install compression fittings on both G1/4 extender openings of the
radiator. Tighten the fitting barbs in the clockwise direction until the
gasket underneath is compressed.
The installation of the radiator and cooling fans is now complete.
METHOD 2
INSTALLING THE RADIATOR AND FANS IN
ONE GO
STEP 1
Prepare your suitably-sized PC chassis for the installation of the
radiator unit. The position of the unit in the chassis depends on its size,
fan mounting holes, and hardware that is installed. You must make
sure the unit fits into the case. Usually, cases already have standard
pre-drilled fan-mounting holes, and you should look for those with a
spacing of 105mm (for standard 120mm computer cooling fans) or
125mm (for 140mm cooling fans).
Fitting Barb
Fitting Ring
PC Chassis
Radiator/Fan unit
UNC 6-32 x 5 Screw
STEP 1
STEP 4
STEP 3
