/ 24 /
STEP 2
The position of the unit will depend on the fan mounting holes and
hardware that is installed in the chassis. Usually, cases already have
standard pre-drilled fan-mounting holes, and you should look for
those with a spacing of 105mm.
Place four M4 x 6 DIN7984 screws into the holes of the bracket from
the upper side.
Alternatively, you can drill four Ø4.5mm holes using an
electric power drill in the most suitable place of your
computer chassis.
STEP 3
Secure the M4 x 6 screws from the previous Step with four (4) M4
nuts and PVC washers. Tighten them with a 2.5mm Allen key.
Make sure the screws are holding tight but do not
exaggerate with the force applied.
STEP 4
The pump-reservoir unit has clearly marked inlet (IN) and
outlet (OUT) G1/4 ports. Not taking that into account will
lead to reverse flow.
Tighten the fitting barbs in the clockwise direction until the gasket
underneath is compressed.
The installation of the pump-reservoir combo unit is now complete.
PVC Washer
M4 Nut
PC Chassis
Fitting
Barb
Fitting
Ring
PC Chassis
Pump-Reservoir
Unit
120mm Fan
Holder Spider
M4x6 Screw
STEP 2
STEP 3
STEP 4