EKOM DK50 9x4VRT/M, Руководство пользователя

Страница: 36 / 45

DK50 9x4VRT/M
NP-DK50-9x4VRTM_ED-EN-2_10-2018 - 36 - 10/2018
18.8. Cleaning / replacing the
compressor’s intake filters (*)
(Fig. 21, Fig. 22)
(*) - only applicable to enclosed products.
Clean or replace the inlet filters at defined
intervals (Table 3) using the following
procedure:

Remove the nuts (1) and covers (4) on
the lower part of the enclosure beneath
the air pumps two times and remove
the filters (5).

Remove the nuts (1) and covers (2)
inside the enclosure three times and
remove the filters (3).

Clean or wash the filter if heavily
contaminated in a solution of soapy
water and allow to dry completely.

Reinstall the filters once dry (reverse
the procedure to reassemble).

In Point A, remove the foam, remove the 4
screws (5), washers (6) and remove the
suction filter cover (7). – (Fig. 21)

Remove the 2 nuts (8) on the filter bracket
(9) and remove the filter (10).

In Point B (on the sides (11)), remove the 2
nuts (12), washers (13), release the filter
bracket (14) and remove the filter (15).

Clean or wash the filter, if heavily
contaminated, in a solution of soapy water
and allow to dry completely.

Reinstall the filters once dry (reverse the
procedure to reassemble
).
A
B
C D
E
F G
H
I
Fig .20