EKKO ES100E, Руководство оператора и по обслуживанию

Страница: 32 / 65

Operating Instructions
30
Battery and Charger
Instruction
Observe and obey
：
√ Do not use an external charger or booster
battery.
√ Charge the battery in a well-ventilated area.
√

Use proper AC input voltage for charging
as indicated on the charger.
√ Use only a authorized battery and
charger.
To charger Battery
1. Be sure the batteries are connected
before charging the batteries.
2. Open the battery compartment. The
compartment should remain open for the
entire charging cycle.
Maintenance-free batteries
1. Connect the battery charger to a
grounded AC circuit.
2. The charger will indicate when the battery
is fully charged.
Standard Batteries
1 Remove the battery vent caps and check
the battery acid level. If necessary, add
only enough distilled water to cover the
plates. Do not overfill prior to the charge
cycle.
2 Replace the battery vent caps.
3 Connect the battery charger to a
grounded AC circuit.
4 The charger will indicate when the battery
is fully charged.
5 Check the battery acid level when the
charging cycle is complete. Replenish
with distilled water to the bottom of the fill
tube. Do not overfill.
Dry Battery Filling and Charging
Instructions
1. Remove the battery vent caps and
permanently remove the plastic seal from
the battery vent openings.
2. Fill each cell with battery acid (electrolyte)
until the level is sufficient to cover the
plates. Do not fill to maximum level until
the battery charge cycle is complete.
Overfilling can cause the battery acid to
overflow during charging. Neutralize
battery acid spills with baking soda and
water.
3. Install the battery vent caps.
4. Charge the battery.
5. Check the battery acid level when the
charging cycle is complete. Replenish
with distilled water to the bottom of the fill
tube. Do not overfill.
Fall protection
Personal fall protection equipment (PFPE) is
not required when operating this machine. If
PFPE is required by job site or employer rules,
the following shall apply:
All PFPE must comply with applicable
governmental regulations and must be
inspected and used in accordance with the
manufacturer’s instructions.
After every using:
1. Select a security place which can be a
sturdy surface, without obstacles and
avoiding heavy transport.
2. Lower the platform.
3. Turn off the machine and remove the key
to avoid unauthorized use.
4. Lock the wheels of the machine.