PD120 OWNERS MANUAL
Drawing No. :- TPC368
Issue
:- 6
Date
:- 07/09/18
UNPACKING
Carefully remove the PD120 dehumidifier unit from its transit box and visually check for signs
of transit damage. If there is evidence of damage DO NOT attempt to operate the unit, call your
supplier for advice. Do not discard the packing, it will be useful when transporting the
dehumidifier unit in the future.
INTRODUCTION
The Ebac PD120 industrial dehumidifier removes moisture from the air through the refrigeration
process.
The Ebac PD120 is basically comprised of:
1)
A compressor
2)
A refrigerant evaporator coil
3)
A refrigerant condenser coil
4)
One circulation fan
5)
A remote humidistat
6)
A cabinet to house the above components
The fan draws the moist air through the cold evaporator coil which cools the air below its dew
point. Moisture forms on the evaporator coil and is collected in the condensate tray which is
equipped with a permanent drain. The cooled air then passes through the hot condenser coil
where it is reheated using the same energy removed during the cooling phase, plus the additional
heat generated by the compressor. The air is therefore discharged from the dehumidifier at a
slightly higher temperature with a lower absolute humidity than with which it entered.
Continuous circulation of air through the dehumidifier gradually reduces the relative humidity
within the area.
The PD120 dehumidifier is a rugged, reliable drying unit designed to operate effectively over a
broad range of temperature and humidity conditions.
The PD120 dehumidifier uses a remotely mounted adjustable humidistat to enable you to select
the level of dryness.
