7
GB
Press the tip of the screw firmly
against the material in question
until the screwing depth stop (1)
comes up against the workpiece
and the coupling disengages.
4.4 Changing the tool insert
To change the tool insert, rotate the
screwing depth stop (1) with the
depth setting ring (2) as far as the
maximum screwing depth and pull
off the tool insert to the front (use
pincers if necessary).
4.5 Screwdriving work
It is advisable to use self-centering
screws (e.g. Torx, cross recessed
head) as these will enable you to
work safely and reliably. Always
make sure that the tool insert used
is of the same size and shape as
the screw.
5. Maintenance
앬
Always keep the screw gun
clean.
앬
Never use caustic agents to
clean plastic parts.
앬
In case of excessive sparking,
have the carbon brushes re-
placed only by a qualified
electrician.
앬
Keep the air vents clean.
6. Technical data
Mains voltage
230V~ 50 Hz
Power rating
710 W
Idle speed
0-4000 min
-1
Tool holder
1/4” hex
Sound power level, LWA
100,4 dB (A)
Sound pressure level, LPA
87,4 dB (A)
Totally insulated
II /
쏾
Weight
2,0 kg
Vibration a
hw
< 2,5 m/s
2
7.0. Ordering replacement parts
Please provide the following infor-
mation on all orders for replace-
ment parts:
앬
Model/type of device
앬
Article number of the device
앬
ID number of device
앬
Number of the required
replacement part
Replacement carbon brushes
42.597.50.01.002
Switch
42.597.50.01.001
Anl BTBS 710_SPK1 23.02.2006 8:54 Uhr Seite 7
