6
GB
1. Layout (Fig. 1)
1. Screwing depth stop
2. Depth setting ring
3. Speed controller
4. Operating switch
5. Locking button
6. Changeover switch
7. Belt holder
8. Chuck
2. Safety information
Please refer to the enclosed book-
let for the safety instructions.
3. Important information
앬
Only ever use screw gun bits
which are suitable for the pur-
pose and in faultless condition.
앬
Before you begin to screw in
walls and masonry, check for
concealed electric wiring, gas
pipes and water pipes.
앬
The screw gun is equipped with
a claw coupling. The spindle
does not start to rotate until the
screw is pushed into the work-
piece.
4. Starting up
4.1 ON/OFF switch (4)
To switch on:
Press the switch (4)
Continuous operation:
Secure the
switch (4) with the locking button
(5)
To switch off:
Press in the switch
(4) briefly
You can select the speed by pres-
sing the switch (4) to a greater or
lesser extent.
You can pre-select the speed by
turning the knurled screw in the
switch (4).
4.2 Forward/reverse switch (6)
Using the slide switch above the
ON/OFF switch you can select the
direction of rotation of the screw
gun and lock the screw gun so that
it cannot be switched on accidental-
ly.
4.3 Screwing depth stop (1)
Using the depth setting ring with
latching settings you can pre-select
(2) the depth to which the screw is
screwed into the workpiece. The
symbols on the setting ring (2) indi-
cate how the screwing depth is set.
Clockwise:
bigger
screwing depth
Counterclockwise: smaller
screwing depth
The best way to determine the re-
quired setting is with a test screw.
The screw is held in place by the
magnetic chuck.
Anl BTBS 710_SPK1 23.02.2006 8:54 Uhr Seite 6
