EIM TEC2000, Руководство по установке и эксплуатации, Страница: 53 / 85

5. Customizing Actuator Settings
TEC 2000 Installation & Operation Manual E2K-405-0902
5-10
5.6.1. Passcode Entry
The actuator is shipped with “000” as a passcode. To change the passcode see Section
5.6.11 , Passcode Setup .
To enter the passcode:
1. At the “ CHANGE SETTINGS? ” prompt answer “ YES .” “ ACCEPT PASSCODE
CHARACTER 1? X ” will appear. “ X ” will be flashing. “ X ” is the first “left most” character in
the passcode.
2. If this character is correct, select YES . If not select NO . Use NO to increment from 0-9
and then A-Z until the correct character is displayed. Select YES . The second character
will flash.
NOTE: When “Z” is displayed the data will rollover to “0” and continue incrementing.
3. Repeat Step No. 2 for the second and third characters.
NOTE: If the passcode is not the correct passcode, the display will return to “ CHANGE
SETTINGS? ” display.
Figure 5-5 Passcode Entry
Goto next display
see Figure 5-1
CHANGE
SETTINGS?
ACCEPT
PASSCODE
CHARACTER
1? 0
NO
YES
ACCEPT
PASSCODE
CHARACTER
2? 0 0
NO
YES
ACCEPT
PASSCODE
CHARACTER
3? 0 0 0
NO
YES
BACK NEXT
YES
NO
0-9, A-Z 0-9, A-Z 0-9, A-Z
Goto next
display see
Figure 5-4
5.6.2. Valve Control Setup
1. At the “ VALVE CONTROL SETUP? ” prompt answer “ YES .”
2. Use the selector knob ( NEXT/BACK ) to scan the settings until the desired setting is
reached. Place the control knob in the NO position to increment through each setting’s
associated choices. Answer “ YES” to accept the desired choice. See Figure 5-6 .
See
Section 4.6 , Remote/Auto Control Operation , for a description of each control mode.
If “ MULTI-PORT VALVE ” control mode is selected, the alarm message “ SET LIMITS
BEFORE OPERATION “ will be displayed and the yellow LED will flash. See Section 5.6.3 ,
Set Valve Travel Limits .