34
WWW.EILERSEN.COM
Analog output connector
The 3 pin analog output connector (J5) can be used for output of analog control signals from
the 5024 system. This connector has the following pin-out:
J5 pin
Function
1
Reserved for future use
2
Reserved for future use
3
Reserved for future use
Ethernet connector
The RJ45/Cat5 Ethernet connector (J7) is a standard Ethernet connector that can be used to
connect the 5024 system to Ethernet.
Jumper settings
The 5024G has three internal jumpers:
Jumper
Function
JP1
Reset
The jumper allows reset of the on-board microcontroller.
OFF: Normal operation (normal setting from factory)
ON: Reset of the 5024 on-board microcontroller
JP2
BOOT Load
The jumper is used when downloading new software to the 5024 system using the J8
serial connector.
OFF: Normal power-up/operation (normal setting from factory)
ON: Download operation possible (see download description)
JP3
Configuration jumper
(Reserved for future use)
Light Emitting Diodes (
LED’s
)
The 5024 system is equipped with a number of internal LED:
LED
Function
D7
(Green)
Load cell Tx (RS485)
Data is transmitted to the load cell.
D8
(Red)
Load cell Enable (RS485)
Transmission to the load cell is enabled.
D9
(Yellow)
Load cell Rx (RS485)
Data is received from the load cell.
D16
(Yellow)
External Rx (RS485)
Data is received from external equipment.
D17
(Red)
External Enable (RS485)
Transmission to external equipment is enabled.
D18
(Green)
External Tx (RS485)
Data is transmitted to external equipment.
