Eiki LC-X80, Руководство пользователя

Страница: 78 / 80

78
Serial Control Interface
This projector provides a function to control and monitor the projector's operations by using the RS-232C serial
port.
Connect a RS-232C serial cross cable to CONTROL
PORT on the projector and serial port on the PC.
(See p.20)
Launch a communication software provided with PC
and setup the communication condition as follows:
1
2
3
Baud rate : 9600 / 19200 bps
Parity check : none
Stop bit : 1
Flow control : none
Data bit : 8
Type the command for controlling the projector and
then enter the "Enter" key.
Example
When you want to change the input to INPUT 2, Type
'C' '0' '6' 'Enter'.
✔ Note:
• Enter with ASCII 64-byte capital characters and one-
byte characters.
✔
Note:
• The default of the baud rate is set to 19200 bps. If an
error occurs in the communication, change the serial
port and the communication speed (baud rate).
The command is sent from PC to the projector with the
format below;
'C' [Command] 'CR'
Command: two charactors (refer to the command
table on next page.
The projector decodes the command and returns the 'ACK'
with the format below;
'ACK' 'CR'
Format
Operation
Appendix