-
49
-
D M
D O M O S
M U L T I
R A D I O
hk
1
2
3
4
5
6
8
9
7
0/
10
1-
/11
2-
/12
SET
MU
TE
TV
VI
DEO
MA
C1
MA
C2
MA
C3
MA
C4
KI
DS
TXT /
TV
EG
i SYS
TEM
AU
X1
AU
X2
AU
X3
TV1
TV2
VC
R1
VC
R2
SAT
1
SAT
2
OF
F
PROGRAMING OTHER REMOTE CONTROLS FUNCTIONS IN THE M13N
The M13N Remote control is able to learn other commonly used functions from other remote controls in adition to the
functions of your
installation. Most of the time you can use a single M13N Remote control for everything and put
away the others. You have three free function banks available, in adition to "EGi SOUND SYSTEM", to store functions
from other appliances.
The codes of over 3500 models of TV, CRD, VCR, DVC, SAT, LC, CD, VCD, etc. are also saved in a pre-programmed memory.
These codes are listed in the "Annex" section.
The programming sequence is as follows:
1.- Put the remote control whose functions are going to be copied opposite to the M13N, at approx. 3 cm.
2.- Press SET + the key that corresponds to the device (TV1, TV2, ...) in which you want to save the new set of commands.
Release both keys when the LED turns ON.
3.- Press the key "0" three times [enter "000"] and the unit will enter the command storage mode.
4.- Press the key of the M13N where you want to save the first command. Then release it. The LED will blink showing
that the M13N is waiting to receive a command from the original remote controller. (After 15 seconds without
pressing any key the M13N will exit the storage mode).
5.- Press continuously the key in the original remote controller that corresponds to the function that you want to
“copy”. The LED of the M13N will light continuously showing that the command is being analysed. Pay attention
to this LED, and see what of the three following options happen:
- If it blinks once and then it stays ON, the storage is O.K. and you can release the button and proceed with the next
command from point 4 on.
- If it blinks three times and then it stays ON, there is a storage error. Check the position of the remote controllers
(see attached drawing), clean the transmitters and check the batteries.
- If it blinks six times then the M13N is out of memory. You can try again or press the device key again (TV1, TV2...) to exit.
If, after the programming sequence, you return to point 3 and enter the code "910", the commands will be safed from
alteration or misinterpretation, even during the process of battery replacement.
If, after the programming sequence, you return to point 3 and enter the code "990", all the new commands that have been
stored will be erased, and the remote controller will be reset back to its default set of commands.
HOW TO ACTIVATE THE SET OF COMMANDS FOR OTHER DEVICES
To use the M13N remote control unit with other electronic devices, first you must choose the command bank that
matches with the electronic device that has to be controlled (TV, VCR, DVD, etc).
To do that, press the “SET” key and, simultaneously, the key that represents the device (TV1, VCR1, SAT2, etc) to be
connected. The record led will light.
After that, enter the numeric code corresponding to the specific device, that can be found in the annex at pages 50 to
54 of this manual. Once the code is entered, the led will turn off.
M13N
1130_E
M13N
3 cm.
1130_A
Free banks
Bank (do not record)
Recording functions from other remote controls
