EGAmaster 79617, Руководство по эксплуатации

Страница: 8 / 58

8
Greases ( free of resins and
acids)
Multi-purpose greases for
antifriction and friction
bearings
Special greases for high-speed
miter gears
Designation in accordance
with DIN 51502 Consistency
class (DIN 51818)
Saponification type Dripping
point Worked penetration
Temperature range
K L 2 k
2
Lithium
185 °C
265 to 295
-25°C to + 125°C
G 000 h
00
Sodium
145°C
400 to 410
-25°C to + 100°C
Before starting: Check correct oiler setting!
Oiler types used on or with our tools
Oiler to mount on the machine or connect in
the hose line
Setting the oiler: The adjustment screw item 2
is visible after removing the screw plug item
3. Theoil supply is decreased by tightening
the screw, and by loosening the screw, more
oil gets into the machine. In most cases it is
sufficient to tighten or loosen the screw by ¼
or ½ of a turn. When plugged, clean borehole
(dia. 2 mm) with wire.
Correct setting; When under pressure and with
the filler screw (item 4) open, the oil must
bubble slightly. The fillint lasts for approx. 8
operating hours.
Line oiler
For stationary pneumatic machines and motors,
the lubrication is carried out by lined-up oilers
for horizontal or vertical installation.
Setting of oilers: Shut off air supply. Open plug
item 3. Loosen visible lock nut item 5 with a
socket wrench. Using a screw driver turn back
the tightened screw plug item 4 by ¼ to ½ of
a turn and then lock again. No oil is to get into
the borehole “a” when filling. Close plug item 3
and open the air supply.
Correct setting: A piece of paper held for a short
time in front of the outlet must be coated with
oil without drops forming.