EGAmaster 79617, Руководство по эксплуатации

Страница: 10 / 58

10
drive block from the rotor and disassemble (watch out for the compensating ring item 47).
Loosen the screws item 88 and 89, remove the gear box cover item 70 and connecting rod item 77.
Remove the screws item 65, pull out the crankshaft item 51 with bearing plate item 62.
Pay attention to compensating ring item 49.
Motor
Unscrew the governor casing item 25 with complete valve. Extract the rotary sleeve item 18
from motor housing.
Motor components as end plate item 7, cylinder bushing item 4, rotor item 11 and end plate
item 13 are pressed forwards out of the motor housing und unscrew the weight clip item 19 from
rear rotor pivot (left-hand thread) and disassemble motor. Check all parts for wear and damage and
replace, if necessary.
Assembly
Assembly is carried out essentially using the reverse procedure. The correct distancing of the
motor must be observed. The axial play between rotor and the end plates should be approx.
0.04mm in both sides. Screws items 79 and hexagonal nuts item 87 for fastening of connecting rod
item 78 must be tightened with 15 Nm and connected with Loctite 242. Tighten cap nuts item
94 with 4 Nm.