EFI Pi6500 Pro, Руководство по настройке

Страница: 48 / 152

2
2-18 Setting up the Pi6500 Pro
TCP/IP Setup with Token Ring
Enable TCP/IP for Token Ring, and enter the IP address and subnet mask. Then, if
your TCP/IP network has a gateway, and users outside the gateway plan to print to the
Pi6500 Pro using TCP/IP, choose Gateway Setup and enter the gateway address (see
page 2-20).
Enable Auto IP Configuration
Yes/No [No]
Select Yes to allow the Pi6500 Pro to obtain its Token Ring IP address. Depending on
your network and the protocol you select in the following option (DHCP, BOOTP, or
RARP), the IP address can change. Select No to assign the Pi6500 Pro a static IP
address, which will not change. If you select No, you proceed to the IP Address option,
where you manually set the IP address.
Select protocol
DHCP/BOOTP/RARP [DHCP]
This option appears only if you answered Yes to Enable auto IP configuration. Select
the protocol over which the Pi6500 Pro should search for its IP address. Both DHCP
and BOOTP allow the Pi6500 Pro to obtain the Token Ring IP address and Subnet
Mask automatically. RARP obtains only the Token Ring IP address.
Depending on your network, the Pi6500 Pro might be assigned a different address
after you reboot the Pi6500 Pro. With the DHCP setting, the Pi6500 Pro can be
assigned a different address even if it is not rebooted.
Make sure the network is already configured properly for the protocol you select.
Network Setup
Protocol Setup
TCP/IP Setup
Token Ring Setup
Enable TCP/IP for Token Ring
Yes/No [No]
Select Yes if you have a TCP/IP network connected to the Pi6500 Pro over Token
Ring. This also enables use of the Fiery WebTools with Token Ring.
N
OTE
:
If you are using TCP/IP for printing from Windows NT 4.0 workstations,
enabling TCP/IP here also enables you to use Fiery utilities from workstations using
TCP/IP protocols.