EEZ RV EezTire E518, Руководство пользователя, Страница: 13 / 35

13
indicate a pressure and temperature remove the sensor and back the
Schrader Valve (valve core) out approximately 1/8 to 1/4 turn and
reinstall the sensor. This will ensure there is sufficient contact and air
pressure to the sensor.
NOTES and RECOMMENDATIONS:
There will be an audible single “chirp,” and the tire will flash if the
monitor has not received a reading from that tire after 30 minutes. If
you are still receiving PSI and Temp readings from the sensors, then
the chirp is an indication of low battery on that sensor. You can also
manually scroll through the tires one by one by pressing the + or -
button. If you manually select a tire the monitor will show its readings
for 10 seconds. The monitor comes equipped with a light sensor; the
backlight will typically come on if the vehicle is in motion and the light
level is low enough. You may also wave your hand in front of the
monitor to manually activate the backlight or by pressing any button.
It can be turned off by pressing the + button for 3 seconds. The light
sensor is located on the lower left of the monitor, just left of the
“LINK” button. The monitor comes with a built -in motion sensor; it
will go to sleep (energy saver mode) if there is no movement of the
vehicle detected for approximately 15 minutes and wake up when it
detects movement. It is recommended that the monitor is shut off
when the system is not in use, or you are staying in the vehicle
overnight. When external power is applied to the monitor it will
override the manual on/off switch on the left side. If you hard wire
your system charger
to a “keyed” switch the system will go off when
the keyed power is turned off. If you are using the auxiliary charging
cord, you will have to unplug the charger manually. You will get a
longer service life from your monitor’s internal battery , if you