EEC ESD-140, Руководство по эксплуатации

Страница: 38 / 43

34
must be included with the command and should appear in the same order that is
shown in the table below. Also, like the individual parameter editing commands, the
unit should not be included with the value. Only the numeric value should be included
in the command string. The list of parameters can also be found in the default
parameters section of the manual, or refer to the Test Parameter Editing commands
section for the proper values. The parameter values should use complete text and not
use the coded values that are eec with the individual parameter setting commands
such as "ON" and "OFF" for toggle field.
GND
1 Step
2 Current
3 Max Limit
4 Min Limit
5 Dwell
6 Frequency
7
Offset
8
Connect (ON/OFF)
Test Parameter Editing Commands
These commands are used to modify the test parameter within each step. These
commands require a parameter value to be included with the command. The writing of
the parameter requires that the unit not be included with the value, only the numeric
value should be included with the command.
COMMAND NAME VALUE
CONN {1|0} Connect ON/OFF 1=On, 0=Off
CURR < value > Edit Current 1.00-40.00A
DDT < value > Dwell Time 0, 0.5-999.9sec
MAXL < value > Edit Max Limit 0-
510mΩ
MINL < value > Edit Min Limit 0-
510mΩ
FREQ {50|60} Edit Frequency 50 or 60Hz
COFF < value > Offset 0-
100mΩ
System Parameter Editing Commands and Companion Queries
These commands are used to modify the system parameters for the instrument.
These commands require a parameter value to be included with the command.
COMMAND NAME VALUE
PLC {1|0} PLC Remote ON/OFF 1=On, 0=Off
SSTP {1|0} Single Step ON/OFF 1=On, 0=Off
ALAR < value > Alarm Level 0-9, 0=Off, 9=High
CNTR < value > Contrast Level 0-9, 9=High
RLT {L|A|P} Result Setting L=Last, A=All, P=P/F
HS {1|0} Hipot Start 0=G

W, 1=G+W