hurricane SB120
2010
13/23
7.8 Guide rail extension
Longer cuts are made with interlocked guide rails. The rails are mounted on the brackets and
fixed loosely. The draw tube is put into the rail end and interlocked with the eccentric bolt. The
second rail is put on and pulled by the second eccentric bolt until the racks of the two rails are in
dead stop position. The rails are centered using a centering pin and centering bushing. Then, the
clamp pads of the fastening brackets can be tightened.
Draw tube with eccentric bolts
Rack in dead stop position
Set up the rails only by hand or with a soft-faced hammer!
Never let the saw touch the limit stops –
danger of breaking!
7.9 Mounting the wall saw
Place the main saw head with attached drive motor on the guide rail, lock on and secure.
Free-from-play locking
There must be no play and no jamming between the rollers and the guide rails in order to achieve
a straight and clean cut. This is achieved by turning the eccentric bolts.
