hurricane SB120
2010
19/23
8 S
AFETY
C
HECKS
,
O
PERATING AND
S
AWING
8.1 Pre-start check
Read and observe the user manual and the safety precautions prior to operation.
Nonobservance of the instructions may result in the uncontrolled start-up
of the machine or damage to the machine. EDT EURODIMA GMBH is not
liable for damage caused in this way.
The machine may only be switched on if all the
electrical connections and cooling water hoses
have been properly connected.
The safety equipment must be checked
All bolts and nuts must be tight
The saw drive must be correctly mounted on the rail and locked.
The blade cover must be in place.
The remote control, electric supply cables and water must be connected.
All control knobs on the remote control and the control unit must be set to zero.
Only operate the wall saw if the blade cover is attached.
Do not touch any movable parts of the machine during start-up
risk of
injury!
Do not operate the machine with damaged parts or if the controls are not
functioning properly.
Defects in the wall saw must be repaired by EDT EURODIMA
or an authorised dealer.
8.2 Operating temperatures
The motor and gear temperature vary according to the temperature of the cooling water and the
water pressure. Therefore the surface temperature of the swivel arm can reach 75
°
C. The water
coming from the blade flange must be lukewarm. This means that the machine is being
adequately cooled.
8.3 Safety coupling
A safety coupling is located between the drive motor and the main saw head in order to prevent
damage to the gears. Sudden jamming of the saw blade induces unpredictable forces that can
damage the machine.
