20
Basic use
Once the connections have been completed (p. 17–p. 18), turn
on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1.
Set the channel LEVEL knobs to the “U”
position.
fig.Adj-Ch-LEVEL
2.
Set the MAIN MIX LEVEL knob and PHONES/
CTRL ROOM knob to the “-
∞
” position.
* Minimize the MAIN MIX LEVEL and PHONES/CTRL
ROOM volume controls before you turn the power on. Even if
the volume is minimized, you may hear some noise when you
turn on the power, but this is not a malfunction.
fig.Adj-MAIN MIX
3.
Switch on the power to your digitally connected
equipment.
4.
Switch on the power to your analog-connected
equipment (musical instruments, sound
modules, effects processors, mics, CD players,
etc.).
5.
Hold down the [POWER] switch until the
display indicates “DIGITAL MIXER.”
When the power turns on, the [POWER] switch will light.
The setup screen will appear, and then after a brief time,
the level meter screen will appear.
fig.03-Setup
6.
Switch on the power to your amp and powered
monitors.
1.
Make sure you’ve done the following before you
turn off the power.
• The M-10DX’s MAIN MIX LEVEL knob has been set to
the “-
∞
” position.
• The volume of the connected equipment has been
minimized.
2.
Switch off the power to your amp and powered
monitors.
3.
Hold down the [POWER] switch until the
display indicates “Power OFF.”
After a while, the power will turn off and the [POWER]
switch’s light will go out.
4.
Switch off the power to your analog-connected
equipment (musical instruments, sound
modules, effects processors, mics, CD players,
etc.).
5.
Switch off the power to your digitally connected
equipment.
Turning the power on
Turning the power off
