Edge-Core ES3528MV2, Руководство по управлению, Страница: 1114 / 1480

C
HAPTER
35
| ERPS Commands
– 1114 –
wtr-timer
This command sets the wait-to-restore timer which is used to verify that
the ring has stabilized before blocking the RPL after recovery from a signal
failure. Use the no form to restore the default setting.
S
YNTAX
wtr-timer minutes
minutes - The wait-to-restore timer is used to verify that the ring
has stabilized before blocking the RPL after recovery from a signal
failure. (Range: 5-12 minutes)
D
EFAULT
S
ETTING
5 minutes
C
OMMAND
M
ODE
ERPS Configuration
C
OMMAND
U
SAGE
If the switch goes into ring protection state due to a signal failure, after the
failure condition is cleared, the RPL owner will start the wait-to-restore
timer and wait until it expires to verify that the ring has stabilized before
blocking the RPL and returning to the Idle (normal operating) state.
E
XAMPLE
Console(config-erps)#wtr-timer 10
Console(config-erps)#
clear erps statistics
This command clears statistics, including SF, NR, NR-RB, FS, MS, Event,
and Health protocol messages.
S
YNTAX
clear erps statistics [ domain ring-name ]
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#clear erps statistics domain r&d
Console#