Edge-Core ECS3510-10PD, Руководство по управлению

Страница: 1077 / 1494

C
HAPTER
33
| Spanning Tree Commands
– 1077 –
spanning-tree
pathcost method
This command configures the path cost method used for Rapid Spanning
Tree and Multiple Spanning Tree. Use the no form to restore the default.
S
YNTAX
spanning-tree pathcost method { long | short }
no spanning-tree pathcost method
long - Specifies 32-bit based values that range from
1-200,000,000. This method is based on the IEEE 802.1w Rapid
Spanning Tree Protocol.
short - Specifies 16-bit based values that range from 1-65535.
This method is based on the IEEE 802.1 Spanning Tree Protocol.
D
EFAULT
S
ETTING
Long method
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
The path cost method is used to determine the best path between
devices. Therefore, lower values should be assigned to ports attached
to faster media, and higher values assigned to ports with slower media.
Note that path cost ( page 1085 ) takes precedence over port priority
( page 1092 ).
◆
The path cost methods apply to all spanning tree modes (STP, RSTP
and MSTP). Specifically, the long method can be applied to STP since
this mode is supported by a backward compatible mode of RSTP.
E
XAMPLE
Console(config)#spanning-tree pathcost method long
Console(config)#
spanning-tree
priority
This command configures the spanning tree priority globally for this switch.
Use the no form to restore the default.
S
YNTAX
spanning-tree priority priority
no spanning-tree priority
priority - Priority of the bridge. (Range – 0-61440, in steps of 4096;
Options: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672,
32768, 36864, 40960, 45056, 49152, 53248, 57344, 61440)
D
EFAULT
S
ETTING
32768