Operating the Unit
Turning the Unit On/Off
Press the Power button on the Control Panel or
use the Remote to turn the unit on. The unit will
initially be set to Normal Mode. Press the Power
button once more to turn the unit off.
Normal Mode
Press the Mode/Coverage button until “Normal”
is shown in the lower right of the Display window.
• Square footage not available in “Normal” – see
Initial Setup: Initial Settings
• To control the fan speed: Use Fan Speed + and -
buttons.
High Mode
• Press the Mode/Coverage button to verify
that “High” is shown in the lower right of the
display.
• To set the square footage on the display, Use the
Mode/Coverage Up/Down buttons – see Initial
Setup: Initial Settings.
• To control the fan speed use the Fan Up/Down
buttons.
CAUTION:
Never adjust the setting to exceed
square footage of ventilated space being treated.
Using Sani + Booster
Press the Sani + Booster button and verify that
“Away” is shown in the lower right of the display.
• To set the Sani + Booster timer, press the Sani
+ Booster button. Each press of the Sani +
Booster button increases the running time of
the Sani + Booster.
• Select 0:30, 1:00 or 2:00 hours.
• Press the Sani + Booster button once more to
switch the unit back to Normal Mode.
LCD Reminders
Replace Plate
When “Replace Plate” appears, the Purification
Plate has reached the end of its useful life and
must be replaced. To order a replacement, go to
www.edenpuresupport.com. Once a replacement
has been obtained, follow the instructions in the
“Disassembly/Assembly” section to replace your
old Purification Plate with your new one.
Replace PCO Cell
When “Replace PCO Cell” appears, the PCO Cell
has reached the end of its useful life and must
be replaced. To order a replacement, go to www.
edenpuresupport.com. Once a replacement has
been obtained, follow the instructions in the
“Disassembly/Assembly” section to replace your
old PCO Cell with your new one.
Perform Cleaning
“Perform Cleaning” will display once the 30-day
operation cycle between cleanings has passed.
The unit will require a complete cleaning. Follow
the instructions in the “Cleaning” section, then
see the “Resetting Reminders” below to reset the
reminders. The “Perform Cleaning” reminder will
appear again after 30 days.
Resetting Reminders
After replacing the Purification Plate or the
PCO Cell, the corresponding reminders will
reset themselves. After cleaning the unit, you
should reset the reminders by holding down the
Maintenance Reset button on the Control Panel
of the unit. The reminder has been reset when
“Perform Cleaning” no longer appears on the
panel.
Operations
Diagrams
