Unit:
Model Number: A6004
Size: 12" x 12" x 9"
Weight: 8.8 lb.
Input: 100-240 VAC 50/60 Hz 2.0 A
PCO Cell:
Normal Mode Output: < 0.02 ppm ozone (ambient room concentration)
Purification Plate:
High Mode Output: 25-360 mg ozone per hour
Ionization:
24-30 KV, 20-30 Khz Ion Generation Pulsator
6 KV DC Needle Ion Generator
Your unit should be cleaned monthly to be kept running at peak performance. Depending on
the pollution and odor levels present during initial set-up, it is advisable to clean the unit more
frequently until the environment has been treated.
Cleaning the Exterior of the Unit
Wipe down the exterior with a damp cloth or use compressed air or a vacuum cleaner to remove dust.
Use an alcohol-based cleaning product to clean the surfaces of the unit.
Cleaning the Filter Assembly
You may use clean water or compressed air to clean your Filter Assembly once it has been disassembled.
Cleaning the Ionization Needle
Use compressed air to blow off any dust that may accumulate near the Ionization Needle.
Cleaning the PCO Cell
Using compressed air or a vacuum cleaner, blow and/or vacuum the dust out of the PCO Cell. Do not use
liquid to clean the PCO Cell.
Cleaning the Purification Plate
Using a 50/50 mix of warm water and clear ammonia (100% white vinegar can be used in place of water
and ammonia), soak the Purification Plate for 8-10 hours but do not exceed 12 hours. Using a soft
bristle brush, scrub the wire mesh to remove debris lodged inside the mesh. Rinse thoroughly. Allow the
Purification Plate to air dry completely before reinstalling. After reinstalling, use a soft cloth and rubbing
alcohol to clean the contacts on the interior of the unit that touch the Purification Plate.
Cleaning the Interior of the Unit
Using a damp cloth, a clear alcohol-based cleaner, compressed air or a vacuum cleaner, carefully clean the
walls and components inside the unit only after completing the Disassembly process.
• Never operate unit near a heat source, open flame or flammable/combustible fluids.
• Do not operate unit unless all parts (including PCO Cell, Purification Plate, Rear Filter Assembly and
Rear Cover) are properly installed.
• Directly viewing the lamp inside the unit for an extended period (longer than 20 minutes) may result in
eye damage.
• Do not use the SANI + BOOSTER in occupied spaces. Short term exposure to ozone levels exceeding
0.5 ppm can cause temporary adverse reactions.
• Make sure you turn the unit Off and unplug the power cord before cleaning, disassembling,
reassembling or servicing the unit.
Specifications
Cleaning
Warnings
