edenox DBM-211-M-W, Руководство пользователя

Страница: 13 / 37

6
edenox.com
ENGLISH
WARNING!!!
Prior to first use, it is necessary to remove the protective film and the protective substance
from the surfaces of the bain
-
marie chambers, to check that the drain valve is closed, and to add water
to the tank (to at least 2 cm from the bottom).
3. OPERATION
3.1 General information
3.2 Description of the control panel.
3.3 Operation modes and configuration of the device.
3.1 GENERAL INFORMATION.
Follow the instructions below to make work and operation safe, as well as to ensure the
durability and fault
-
free operation of the device:

provide training for the personnel who is to use the device in the operation of professional
electrical gastronomic equipment;

the device may be repaired only by an authorised person;

damaged components or subassemblies should be replaced with the same items or ones with
similar durability, features and technical parameters.
The following must always be observed:

do not connect the device to the mains via a socket that is NOT provided with an earthing pin;

do not connect the device to an electrical system that has not been checked for fire safety;

do not clean or have the device maintained when connected to the power supply.
WARNING!!!
DO NOT wash the bain
-
marie using a water jet.
WARNING!!!
The manufacturer shall not be held liable if the device is used without the observation of this
manual or outside of its intended use.
3.2 DESCRIPTION OF THE CONTROL PANEL.
The control panel (Figure 2,
D
) is located on the right
-
hand side of the device, under the water
chamber. Depending on the model, the panel comprises a set of two, three, or four (Figure 1)
thermostat controls (A) with a control lamp (B) and one power switch (C) located on the right
-
hand
side of the panel. These controls are used to adjust the water temperature in the corresponding w
ater
chambers of the device. It is steplessly variable with a range of 30
°C
to 90
°C
.
Located at each control (Figure 1, B), the lamps show if the water has reached the desired
temperature. The power switch is used to turn on and off the device by setting it to 1 or 0 respectively.