edenox DBM-211-M-W, Руководство пользователя

Страница: 10 / 37

3
edenox.com
ENGLISH
The conductor diameter of the power cable should not be smaller than the values given in the table
below.
Model
Designation of the power cable
(type, number of conductors, cross
-
section area of conductors)
DBM
-
211
-M-W
DBM
-
311
-M-W
PCG 3 x 1.
5
mm
2
DBM
-
411
-M-W
PCG 3 x
2
.
5
mm
2
The power switch should be connected directly to the power terminal (electric cabinet), while
making it possible to safely and reliably disconnect all phases powering the device. When the circuit is
broken, the gap between the jumpers of the switch should not be smaller than 3
mm
.
After installation, the device must be checked for leakage conductance. The value of leakage
conductance per 1
kW
of the power of the device should be lower than 1
mA
.
Warning!!!
If an equipotential bonding bar is required, its connections must be checked.
2.2 TRANSPORT, LIFTING, UNPACKING, STORAGE.
Correct and safe transport:
• use equipment appropriate for the weight and structure of the devices;
• cover corners and sharp edges;
Before carrying:
• secure the area against unauthorised personnel;
• make sure that the load is properly secured;
• check all loose components lest they should fall when being lifted;
• try to lift the load as vertically as possible so as not to make any dents in it;
• while carrying the load, make sure that it is as near the ground as possible.
2.3 INTENDED USE AND LIMITATIONS.
Featuring the GN containers, the water bain
-
marie is used to keep and display hot meals that
have been prepared beforehand, allowing them to be served later.
Before using the water bain
-
marie, its electrical system needs to be checked for efficiency and
reliability.
After work, set the power control to 0 (see Figure 1, ‘
Point 0’
).
Switch off the device by setting the control on the panel to 0 (Figure 1, ‘
C
’), and then
disconnect the power cable of the water bain
-
marie.