EN
Instruction Manual
[27]
MACHINE INTRODUCTION
2.1 INTRODUCTION TO MACHINE & MODELS
The purpose for which this equipment has been designed is to be built into a self-service buffet,
a drop in or any work top and is specially conceived to improve the presence of the food by
giving the necessary lighting or heating.
The heated foodshields are not suitable in any case to heat up the food, they only provide
additional heat to the lower technical element. In any case, the food displayed must have been
previously heated.
The foodshields have measurements equivalent to 2, 3, 4,5 and 6 gastronorm 1/1 and are
specially designed to be installed on different components of the Drop-in range (both cold and
hot tops and wells).
However, they can also be mounted on any other worktop.
2.2 IMPORTANT SAFETY INFORMATION
The in-situ installation and start-up of this appliance must be carried out by qualified technical
personnel. The technical parameters inside this manual are subject to change without
notification.
The appliance must be only repaired by qualified personnel. Please contact your distributor and
do not attempt to open this appliance.
If the appliance is not going to be used for extended periods of time, make sure it is cleaned and
disconnected from the mains electricity supply.
Make sure that external sources do not influence the appliance that may prejudice its
performance (direct sources of air, strong vibrations or similar).
This appliance is made of stainless sheet steel and there are risks of cutting inherent in its design.
Please take extra exceptional care when handling and cleaning it.
The hot can reach elevated temperatures and consequently there is a risk of burns.
Do not allow children to handle the appliance under any circumstances.
2.3 SPECIFICATION CHART
Please check Table 1 and 2 for detailed information of the product.
INSTALLATION
3.1 GENERAL INFORMATION
ANY TECHNICAL MAINTENANCE MUST BE CARRIED OUT BY YOUR DISTRIBUTOR'S TECHNICAL
ASSISTANCE SERVICE.
3.2 TRANSPORT, HANDLING, UNPACKING, LOCATION
On receiving the device, make sure that it has not suffered any damage in transport. Otherwise,
make all pertinent claims to your supplier or to our company.
The warranty will only cover manufacturing defects, excluding any incorrect handling or use of
the material by the clients or users. Labor costs and travelling expenses are always in charge of
the client. Any responsibility for defects attributable to transport will not be accepted, unless
the relevant claim is placed within a maximum period of 24 hours after receiving the goods.
When the device has been accepted, it is preferable to keep it unpacked until it is put into service
to protect it from any possible mechanical knocks, dust, dirt, etc.
