EN
Instruction Manual
[29]
When foodshield is installed on a refrigerated drop in unit of the manufacturer, the complete
set will have one single power cord (if required); however, for hot elements the drop in and the
foodshield will have independent power cord as standard.
As shown in Figure 19, additional accessory can be assembled into the foodshield.
OPERATION
4.1 CONTROL PANEL DESCRIPTION
The appliance is turned on by pressing the start-up switch of the thermostat in the drop in or
the self service. If the foodshield is assembled in other equipment, you should buy an additional
switch on accessory.
4.2 MACHINE SETTINGS AND PROGRAMS
INSTALLED OPERATION SYSTEMS:
The illuminated foodshields include high performance and low consumption LED.
The heated foodshields provide light and heat by means of ECO halogen lamps (lower
consumption than standard lamps) protected with glass.
Foodshields with light and heat with ceramic infrared glasses, provide more intense and
concentrated heat.
MAINTENANCE
5.1 GENERAL SAFETY RULES
Remove the exterior plastic protection and any remaining adhesive covering the steel.
Clean carefully before using by following the specific instructions detailed later in this manual.
Before carrying out any operation on the equipment, always check this manual which gives the
correct procedures and contains important information on safety.
5.2 MACHINE CLEANING AND MAINTENANCE ROUTINE
Any technical maintenance must be carried out by your distributor’s technical assistance
service. IMPORTANT: Take special care as after using the appliance as the stainless steel
remains hot for some time, even when it is switched off (residual heat). Please try not to touch
it with bare hands and keep away from children
To clean the appliance, it is recommendable to firstly disconnect the same from the mains
electricity supply. Do not splash water on the electric components.
CLEANING ADVICES
•
To clean the stainless steel, use a sponge or cloth, tepid water and neutral soap. Do not
use abrasive products, solvents, metal cleaning liquids or undiluted detergents.
•
Dry with a cloth afterwards.
5.3 MACHINE DISPOSAL
The product is made of metal parts. The packaging is made of plastic and cardboard. For any
part of the appliance, please note that:
