7
en
gettIng started
8. Start driving slowly, and, if the vehicle does not go straight,
adjust the steering trim dial on the transmitter.
All model car engines must use a properly oiled air filter to keep dirt
out of the engine. Any dirt that enters the carburetor can damage your
engine. Clean and re-oil the air filter after each hour of use to prevent
dirt from entering the engine. If you intend to run your vehicle
in extremely dusty conditions, the air filter should be serviced
after every 1/2 hour.
6. Do a test of the transmitter’s control of the vehicle
with the vehicle’s wheels off the ground.
5. Fill the fuel tank with nitro
fuel and power on the receiver.
POWER
ST. TRIM
TH. TRIM
ST. RATE
4. Power on the transmitter.
7. Start the vehicle according
to the instructions on the
following page.
fuel storage Precautions and guidelines
• When finished running your vehicle, always run your engine until
the fuel tank is empty. Do not store the vehicle with fuel in the
engine.
• Never handle model engines and mufflers until they have had time
to cool. They become extremely hot when in use.
• Always store your fuel in a safe place well away from sparks,
heat or anything that can ignite.
• Always ensure that fuel is stored in a clearly marked container
well away from the reach of children.
• Always store your fuel safely in a sealed, water-resistant container
specifically made for gasoline.
• Always store fuel in a cool, dry location, out of direct sunlight. Do
not allow fuel containers to come in direct contact with concrete,
as the fuel may absorb moisture.
• Always responsibly discard fuel if there is condensation and/or
water inside the fuel container.
• Never allow fuel to come into contact with eyes or mouth.
Fuels used in model engines are poisonous.
• Never return unused fuel from the fuel tank back into
the fuel container.
(wire tie)
(wire tie)
1. Assemble the air filter. Install the
wire tie at the 5 position, ensuring
that the wire tie is secure.
2. Remove the rubber cap from
the carburetor inlet.
3. Install the air filter onto the
carburetor inlet. Install the
wire tie at the 6 position,
ensuring that it is secure.
