13
en
lIMIted Warranty
What this Warranty covers
Horizon Hobby, Inc. (“Horizon”) warrants to the original purchaser
that the product purchased (the "Product") will be free from defects
in materials and workmanship at the date of purchase.
What is not covered
This warranty is not transferable and does not cover (i) cosmetic
damage, (ii) damage due to acts of God, accident, misuse, abuse,
negligence, commercial use, or due to improper use, installation,
operation or maintenance, (iii) modification of or to any part of the
Product, (iv) attempted service by anyone other than a Horizon
Hobby authorized service center, (v) Product not purchased from
an authorized Horizon dealer, or (vi) Product not compliant with
applicable technical regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON MAKES NO
OTHER WARRANTY OR REPRESENTATION, AND HEREBY DISCLAIMS
ANY AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT
LIMITATION, THE IMPLIED WARRANTIES OF NON-INFRINGEMENT,
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE
PURCHASER ACKNOWLEDGES THAT THEY ALONE HAVE DETERMINED
THAT THE PRODUCT WILL SUITABLY MEET THE REQUIREMENTS OF
THE PURCHASER’S INTENDED USE.
Purchaser’s remedy
Horizon’s sole obligation and purchaser’s sole and exclusive remedy
shall be that Horizon will, at its option, either (i) service, or (ii) replace,
any Product determined by Horizon to be defective. Horizon reserves
the right to inspect any and all Product(s) involved in a warranty claim.
Service or replacement decisions are at the sole discretion of Horizon.
Proof of purchase is required for all warranty claims. SERVICE OR
REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE
PURCHASER’S SOLE AND EXCLUSIVE REMEDY.
limitation of liability
HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL
OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION
OR COMMERCIAL LOSS IN ANY WAY, REGARDLESS OF WHETHER
SUCH CLAIM IS BASED IN CONTRACT, WARRANTY, TORT, NEGLI-
GENCE, STRICT LIABILITY OR ANY OTHER THEORY OF LIABILITY,
EVEN IF HORIZON HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES. Further, in no event shall the liability of Horizon exceed the
individual price of the Product on which liability is asserted. As Horizon
has no control over use, setup, final assembly, modification or misuse,
no liability shall be assumed nor accepted for any resulting damage
or injury. By the act of use, setup or assembly, the user accepts all
resulting liability. If you as the purchaser or user are not prepared to
accept the liability associated with the use of the Product, purchaser
is advised to return the Product immediately in new and unused
condition to the place of purchase.
Problem
Possible cause
solution
Engine won't
start
• Clogged fuel line
• Bad or improper glow plug
• Glow igniter not charged
• No fuel in carburetor
• Contaminated fuel
• Engine flooded
• Excessively worn engine components
• Split or cracked fuel or pressure lines
• Clean or replace damaged fuel line
• Replace the glow plug
• Fully charge the glow igniter
• Prime the system
• Replace fuel. Do not store nitro fuel on metal or concrete
• Remove the glow plug from the cylinder head. Rotate the vehicle so the cylin-
der head is pointing toward the ground. Pull the recoil 2-3 times to remove any
excess fuel from the cylinder head. Re-install the glow plug.
• Check engine compression and engine bearings
• Replace damaged lines
Engine starts
and then dies
• Engine flooded
• Pressure line blocked or disconnected
• Bad or improper glow plug
• Low fuel
• Split or cracked fuel or pressure lines
• Broken clutch spring
• Excessively worn engine components
• Remove the glow plug from the cylinder head. Rotate the vehicle so the cylin-
der head is pointing toward the ground. Pull the recoil 2–3 times to remove any
excess fuel from the cylinder head. Re-install the glow plug.
• Clean or replace the pressure line
• Replace the glow plug
• Refuel
• Replace damaged lines
• Check clutch springs and replace if needed
• Check engine compression and engine bearings
Engine starts
and runs for
1/2 tank and
then quits
• High-speed needle too lean
• Hole or tear in fuel line
• Defective fuel tank
• Bad or improper glow plug
• Idle speed set too low
• Overheated engine (too lean)
• Improper needle settings
• Richen the high-speed needle 1/4 turn
• Replace the fuel line
• Replace the fuel tank
• Replace the glow plug
• Increase the idle speed 1/12 turn
• Allow the engine to cool and enrich the high speed needle 1/4 turn.
• Return the high and low speed needles to the factory positions.
Low power
output and
performance
• Excessively worn engine components
• Brakes hanging up
• Check engine compression and engine bearings
• Check brake adjustments
trouBleshootIng guIde
