ECS 761GXM-M2, Руководство пользователя, Страница: 56 / 58

50
50
8 Press <Q> again to exit this BIOS utility and the red message frame will
show as the same as the creation of the RAID 0 array. Press <Y> and
<Enter> to save changes.
9 Once the array has been created, you will need to FDISK and format
the array as if it were a new single hard drive.
Creating a JBOD Array
To create an JBOD array, follow these steps:
1 Press <A> to start creating a RAID array.
2 Press <1> and <Enter> to select JBOD.
3 You will have two selections to create a JBOD array. The default
value is <1> . If you select <1>Auto Create , you can create a JBOD
array faster and easier. The result after creating will be show on step
5 . Besides, you also can select <2>Manual Create , see following
steps.
1 SiS 180 enables users to create JBOD arrays with 2,3, or 4 drives.
2 SiS965L only supports 2 SATA drivers to create a JBOD arrays.
4 Use < ↑ > < ↓ > to select disk, and press <Enter> to select disk, <Q> to
exit. When you press <Enter> on the disk you wanted, the RAID Type
will be changed from
Single to JBOD .
5 After all steps finished, press <Q> until escape the setup menu and
JBOD array will be show on the top of the main frame.