22
ECOWATER
S
Y
S
T
E
M
S
Faceplate Controller, Features/Options
The following is a description of the options in the Advanced/Service Menu. To enter any of the following menus,
press SELECT/EXIT (
↵
) to enter Primary Menu. Press the (
↑
) or (
↓
) keypads until cursor is next to Advanced/Ser-
vice. Press the SELECT/EXIT (
↵
) keypad to enter this menu. Warning screen will show, press the (
↑
) keypad
to continue. To exit to Normal Screen Views move square cursor (
J
) to EXIT, which appears at either the top or
the bottom of this menu. If no keypad has been pressed display will show for 4 minutes before defaulting back
to the Normal Screen Views.
Set Language: Press the (
↑
) or (
↓
) keypads until cursor is next to Set Language.
Language can be changed from English to Spanish or French. Warning: If the
language has been mistakenly changed, the following steps can be followed to
reset.
1) Unplug transformer, then reapply power to the unit. After 4 seconds, the time
of day should show in the upper right corner. If the time of day is not shown, press
the SELECT/EXIT (
↵
) keypad until it is.
2) Press the SELECT/EXIT (
↵
) keypad.
3) Press the (
↓
) keypad until the square cursor (
J
) is next to one of the following:
Advanced/Service (English)
Servicio/Avanzando (Spanish)
Fonct avanc (French)
4) Press the SELECT/EXIT (
↵
) keypad.
5) Press the (
↑
) keypad.
6) Press the (
↓
) keypad until the square cursor (
J
) is next to one of the following:
Set Language (English)
Seleccionar idioma (Spanish)
Réglage langue (French)
7) Press the SELECT/EXIT (
↵
) keypad.
8) Language can now be selected by pressing the (
↑
) or (
↓
) keypads until the cur-
sor is next to correct language.
9) Press the SELECT/EXIT (
↵
) keypad to select language.
10) Press the (
↑
) or (
↓
) keypads until cursor is next to EXIT.
11) Press the SELECT/EXIT (
↵
) keypad.
Diagnostics: Press the (
↑
) or (
↓
) keypads until cursor is next to Diagnostics and
press SELECT/EXIT (
↵
). This screen is for viewing only and will show any error
codes plus information about the unit. Use the (
↑
) or (
↓
) keypads to view all lines
of the screen. See page 28.
Set Low Salt Alert: Press the (
↑
) or (
↓
) keypads until cursor is next to Set Low
Salt Alert and press SELECT/EXIT (
↵
). Use the (
↑
) or (
↓
) keypads to change
Alert Level. At this level the controller will signal that salt needs to be added to
the conditioner brine tank. Press SELECT/EXIT (
↵
) to exit.
continued
