Ecotec BioLine 20, Инструкция по эксплуатации

Страница: 10 / 28

10
USING
THE C
ONTR
OL SY
STEM
Status: Operating
u Temperature 60.0°C
Curr. feed xx%
Oper. time xxxxxh
Service 1 xxh
Service 2 xxh
Settings
Settings menu
u
Load burner No
Operating
Pause
External feed
Sensors
Maint. burn
No
Service 1 189h
Reset par. No
This shows the temperature of the
system. With the right arrow button
u
you can set the operating tempera-
ture.
Shows the status.
Stopped=Burner is stopped
Start=Burner is starting
Operating=Burner is operating
Pause=Burner is temporarily paused
The burner can also send alarms. E.g.:
ALARM: Ignition fault=Burner could not start
For the other alarms, see the "Alarms" section.
Shows the proportion of
the maximum fuel feed
that is being used.
Operating hours (internal
motor) left until Service
1. Can be set by customer
and distributor.
The right arrow button
u
opens the Settings
menu.
Shows how many
hours the burner's
internal motor has
been in operation.
Operating hours (internal mo-
tor) left until Service 2.
Can only be set by distributor.
Explanation of the menus
Change to Yes to load the burner
manually. Used e.g. when reset-
ting after the external auger has
run empty.
Stop with the Stop button.
Goes to the
Operating
menu.
Goes to the External
feed menu.
Goes to the
Sensors menu.
Setting of how many hours
to countdown to Service 1.
If you enter 0, the function is
disabled. Service 2 can only
be set by the distributor.
Go to the
Pause menu.
When the maintenance
burn is activated, the feed
time on the Pause menu is
set to 30s. The embers in
the burner do not go out, so
the burner can be restarted
without the ignition ele-
ment.
Resets all the parameters to the
distributor's settings.