Ecosoft RO 5-100, Инструкция по установке и эксплуатации

Страница: 21 / 42

20 21
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2014
ENG
REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE
4. STEPS FOR INSTALLING REVERSE OSMOSIS SYSTEM
3.
Screw the feed water adapter
4
into the cold water plumbing. Screw
the feed valve
5
into the feed water adapter
4
. To help prevent water
leaks use PTFE sealing tape.
Connections size is selected to fit most common size ½ inch pipe. If your pipe is of
another size, prepare an appropriate adapter.
4.
Unscrew the compression nut from the feed valve
5
and put it on
the red tube. Push the red tube on the end of feed valve’s fitting and
screw on the compression nut. Connect the free end of the red tube
with the quick connect fitting of the first (rightmost) housing in the
rack.
5.
Connect the drain saddle
8
with drain pipe from the kitchen sink. The
drain saddle is compatible with most standard drain pipes. Drill a hole
of 5,0 mm diameter in the kitchen sink drain pipe, apply rubber gas-
ket with sticky base (included in the package). Install the drain saddle
8
on the drain pipe over the hole. Tighten nuts on drain saddle with
a wrench. Insert black tube into the connection on the clamp (figure
4). Connect the other end of the black tube with concentrate outlet of
membrane housing.
CAUTION! Check if the flow regulator 12 is installed in the black tube
in the end connected to membrane housing.
6.
Put a few turns of PTFE tape on the thread on tank outlet. Screw the
tank valve onto the tank outlet. Close the tank valve.
IMPORTANT! Check air pressure in empty tank. Tank should be pres-
surized to 0.4-0.6 bar. If necessary, use a pump with a pressure gauge
to increase the pressure or push the core of the valve stem to relieve
pressure.
A
A
A
feed water adapter
Fig. А1 Fig. А2 Fig. А3
feed water adapter
PTFE tape
PTFE tape
feed valve
PTFE tape
PTFE tape
tank valve
feed water adapter
red tube
feed valve
compression nut