11
Setup Procedure
SETUP PROCEDURE
When the water softener is plugged in for the first time,
a beep sounds and the display briefly shows model
information. Next, a series of “wizard” screens prompts
you to enter basic operating information:
FIG. 13
1
.
LANGUAGE
If the desired language already has a
black dot next to it (See Figure 13), go to Step 2.
Otherwise, press the softener’s DOWN (
6
) or UP
(
5
) buttons to scroll to the desired language, then
press the SELECT (
¡
) button to choose it.
2
. Press the SELECT (
¡
) button to advance to the next
“wizard” screen.
English
Metric
System units
FIG. 14
3
.
SYSTEM UNITS
If the desired system already has a
black dot next to it (See Figure 14), go to Step 4.
Otherwise, press the DOWN (
6
) or UP (
5
) buttons
to scroll to the desired system, then press the
SELECT (
¡
) button to choose it.
4
. Press the SELECT (
¡
) button.
12:34 PM
Current time
FIG. 15
Salt level
4
FIG. 17
0.0 PPM
Iron level
FIG. 18
Run system
Redo setup
Setup complete!
FIG. 19
8
. Press the SELECT (
¡
) button.
11
.
IRON LEVEL
Press the UP (
5
) or DOWN (
6
) but-
tons to set the value for iron in your water (See
Figure 18)
12
. Press the SELECT (
¡
) button. The screen will
show “Setup complete!” (See Figure 19).
13
. If, at this point, you want to go back and make
changes, press the DOWN (
6
) button to scroll to
Redo setup
, then press the SELECT (
¡
) button
twice to repeat the “wizard” screens.
14
. If no changes are desired, make sure
Run system
has a black dot next to it (See Figure 19) and press
the SELECT (
¡
) button. The unit begins normal
operation, described on the next page.
5
.
CURRENT TIME
Press the DOWN (
6
) or UP (
5
)
buttons to set the current time (See Figure 15). Hold
the button down to rapidly advance. Be sure that AM
or PM is correct. If the system units were set to met-
ric in Step 3, the clock will be in 24-hour format.
English
Español
Français
Language
NOTE:
Do not increase the hardness setting to
compensate for iron in your water. The
electronic control compensates automatically
after you set the iron level in Step 11, below.
9
.
SALT LEVEL
Press the UP (
5
) or DOWN (
6
) but-
tons to set the salt level (See Figure 17). It should
match the lowest number visible on the brinewell
above the salt.
10
. Press the SELECT (
¡
) button.
25 Grains
Hardness
FIG. 16
6
. Press the SELECT (
¡
) button.
7
.
HARDNESS
Press the UP (
5
) or DOWN (
6
) but-
tons to set the value of your water’s hardness (See
Figure 16).
FIG. 12
Display
LEFT
Button
RIGHT
Button
UP
Button
DOWN
Button
SELECT
Button
