62
X
X
X
X
X
5. Allow remote control, number of call signs before automatic call acceptance
This menu regulates whether the FHZ1000 can be remotely controlled by the alarm dialler and, if yes, after how many
call signs the alarm dialler answers a call.
The following can be set:
• Remote control off (OFF)
• Remote control on, alarm dialler answers after 1/2/.../9 (‘x. Rufz.’) (‘x.call signs’) call signs.
To enter the settings, proceed as follows:
• Briefly press the ‘
x
’ button once.
• Select ‘Sonderfkt.’ (special function) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Alarmw.’ (alarm dialler) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Rufannahme’ (call acceptance) using the scroller.
• Briefly press the ‘
x
’ button once.
• Use the scroller to set the number of call signs (1 to 9). To switch the remote control operation off, set to ‘OFF’.
• To save your settings, briefly press the ‘MAKRO’ button once. The display briefly shows ‘gespeich.’ (saved).
• Pressing the ‘
w
’ button twice transmits the new entries to the alarm dialler. The display shows ‘warten’ (wait) while
it communicates with the alarm dialler by radio and the new settings are transmitted to the alarm dialler. After a
successful transmission the display shows ‘Alles OK’ (everything OK).
• Pressing the ‘
w
’ button twice returns you to the normal operating mode.
• If the transmission fails, ‘K. Empfang’ (no reception) appears on the display. The FHZ1000 then attempts to transmit
the settings again.
Ö
The alarm dialler is ready for operation once the telephone numbers (1 to 3), the dialout number, the PIN and
the call acceptance have been programmed as described above.
X
X
X
X
X
6. Carrying out a test alarm
You can test the alarm dialler via this menu item after the settings necessary for operation have been made. The alarm
dialler calls the programmed telephone numbers (1 to 3) and transmits 5 high-pitched tones (‘H’, ‘H’, ‘H’, ‘H’, ‘H’) to trigger
an alarm. To carry out this test, proceed as follows:
• Briefly press the ‘
x
’ button once.
• Select ‘Sonderfkt.’ (special function) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Testalarm’ (test alarm) using the scroller.
• Briefly press the ‘
x
’ button once.
• ‘Alarmwahl’ (alarm dialling) then appears on the control centre’s display and the control centre communicates with
the alarm dialler by radio.
Ö
If necessary, inform the owners of the programmed alarm telephone numbers before carrying out the test
alarm.
FHT 8W Heat Demand Relay
Installation and User Guide
Product Code EHC-FH06
1
