46
Z
Z
Z
Z
Z
3. b) Remote switching components
For the remote switching components you can also use the ‘Funktion’, ‘PROG’ and ‘
’ buttons and the scroller to
set the states that will be activated when the macro is started.
These operating modes can be selected using the ‘Funktion’ button:
• ‘Auto’,
• ‘Manu’
• ‘Holiday/party function’
Ö
Please note:
If no operating mode is selected (no symbol ‘auto’, ‘manu’ or suitcase symbol ‘ ’ for holiday/party function
is visible on the display), this room controller will not be affected by the macro.
Using the ‘
’ button you can preselect the switching state of the remote component:
• On: Switch on
• Off: Switch off
• No switching state: The device remains in the state in which it is in
Using the ‘PROG’ button the length of time for the holiday/party function (if activated) can be programmed:
• Briefly press the ‘PROG’ button once.
• Set the length of time for the holiday/party function using the scroller. The setting begins at 0.5 hours (‘h’ in the upper
left of the display) in 0.5 hour steps. For a time period longer than 23.5 hours, the setting continues in days (‘d’ in the
upper left of the display).
• Briefly press the ‘PROG’ button once.
• Save the settings by pressing the ‘MAKRO’ button.
• Using the scroller you can select the next remote component and proceed as described above.
• Pressing the ‘
w
’ button 4 times returns you to the normal operating mode.
Example of a macro remote switch setting:
For the two remote switching components ‘path light’ and ‘floor lamp’, the following parameters should become active
when ‘Makro 1’ is activated.
• The path light should be illuminated for a period of 1 hour after the macro has been activated.
• The floor lamp should remain switched on until the next state change is activated for the floor lamp by the switching
program.
To carry out the programming, proceed as follows:
Selecting
‘
Makro 1
’
and the path light:
• Briefly press the ‘
x
’ button once.
• Select ‘Sonderfkt.’ (special function) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Makros’ (macros) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Editieren.’ (edit) using the scroller.
• Briefly press the ‘
x
’ button once.
FHT 8W Heat Demand Relay
Installation and User Guide
Product Code EHC-FH06
1
