MANUAL DE USUARIO
– PROCAM HD II
Página
20
de
44
INMANUUML043 USER M.M. USO PROCAM HD II V.2023.07 ENGESP US
PROBLEM
PROBABLE
CAUSE
SOLUTION
The equipment
will not turn on
It
is
not
connected to the
electric
power
supply.
Connect the cable to the electric power supply.
The power cable
is damaged or
cut.
Replace the power cable.
The plug is in
bad conditions.
Replace the plug.
The fuse is
damaged or
burnt.
Replace the fuse.
The green pilot
light on the
switch turns on
but there is no
image on the
screen
Poor connection
Verify that both ends of the cord are completely
plugged to the connector.
Video Input
processor of the
monitor does not
register the
camera correctly
Turn off the monitor, and turn it on again after 10
seconds.
Turn off the PROCAM HD console and turn it on
again after 10 seconds.
Change the video output at the PROCAM HD
console
If the monitor has more than one video input,
change the connection to another input.
Monitor off.
Turn the monitor on.
Monitor
disconnected.
Plug the monitor to the PROCAM HD console
through the provided cord.
Monitor in wrong
video mode.
Set the monitor in HDMI / DVI / VGA / CVBS
video input. Set the monitor in HDMI / DVI / VGA
or SDI / CVBS video input.
The camera is
not connected.
Connect the camera connector to the front panel
of the console.
Videocamera
incorrectly
connected.
Check if the videocamera connector is correctly
and completely connected to the frontal panel of
the PROCAM HD console.
