ECI CabLite VR Series, Руководство по установке, Страница: 8 / 16

Cablite® VR LED Lighting System Installation Manual Rev 2.1
Electronic Controls, Inc.
7073 North Atlantic Ave. Cape Canaveral, FL 32920
800-633-9788
www.eciamerica.com P a g e | 8
Figure 2 - Dimmer Board
6.4 CabLite® VR with Dimming and Emergency Lighting
CabLite® VR with dimming and emergency lighting includes the following:
•
1 to 12 downlights
•
Emergency Light board (factory wired and mounted in gang box)
•
12 or 24VDC power supply (factory wired and mounted in gang box)
•
6-volt battery for 12VDC systems or 12 Volt Battery for 24VDC systems. (Factory wired w/ +
side disconnected)
•
Two 8’ cables for connecting first downlights (factory wired and located in gang box)
•
One 4’ cable for each additional downlight
•
Electrical box and cover
•
One #10 torx for LED replacement
•
Installation Manual
The CabLite® VR with dimming and emergency comes factory wired in its own gang box. All that is
needed is to connect the prewired 8’ cables to the first downlight and first emergency downlight and
connect the BROWN (LINE) and BLUE (NEUT) wires to 120VAC.
Dimming and emergency lighting is included with this version CabLite VR. Brightness is controlled
through the onboard potentiometer or an external 10k POT (see
Figure 9 - CabLite® VR w/ Dimming &
Emergency Wiring
). A separate 8’ cable is provided for emergency lighting (2 downlights).
In addition, there is a standby mode that will turn off all downlights when cab is not in use. This is
achieved with a key switch connected to the STBY input pins 9 & 10 (see
Figure 9 - CabLite® VR w/
Dimming & Emergency Wiring ).
NOTE: It is important not to turn off lighting through the 110VAC input as this will
engage emergency lighting and drain the battery. Use only the STBY inputs to turn
off cab lighting.
6.4.1 CabLite® VR Emergency Board Connections
Refer to Figure 3 - CabLite VR Emergency Board
•
Pin 1 (IN +) is +12 or +24VDC input power (RED Wire)